ABB PVS300 Manuál stáhnout pdf (Strana 55)

Mechanical installation 55

• If stud work can be located behind the wall surface and the mounting plate holes

can be aligned with it, the mounting plate can be fastened to the stud work.

• If suitable stud work cannot be located, a strong supporting structure (for

example, stud work, boards, railings) must be prepared on the wall surface.

1. Use the pilot securing point (1) to temporarily hang the mounting plate in its

intended location. The vertical centre of the inverter’s keypad will be at the same

height as the pilot securing point and a small distance (W3) horizontally offset to

the left of it.

2. Check that the mounting plate is straight, then mark the securing points (2) to the

wall.

3. Drill holes in the marked positions and fasten the mounting plate to the wall or

mounting base.

4. Either fully tighten or completely remove the pilot securing screw.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 129 130

Žádné komentáře

ABB PVS300 Manuál Strana 55